How To Assemble And Operate The Vacuum; How To Change The Vacuum Bag - Tennant Nobles V-SMU-14 Manuel D'utilisation

How to Assemble and Operate the Vacuum

How to Attach the Handle to the Vacuum Cleaner
The vacuum cleaner and the handle are packed separately.
1. After first removing the handle screw, insert handle
into the hole on top of the vacuum cleaner. (Fig. 4)
2. Line up the small hole on the handle with the small
hole on the vacuum cleaner and insert the screw.
Make sure the screw is secured tightly.
How to Operate the Vacuum Cleaner
V-SMU-14 Model: To turn the vacuum cleaner on, push the On/Off
switch located at the rear of the unit to the ( I ) position (Fig. 5).
To turn the vacuum cleaner off, push the On/Off switch to the ( O )
position.
V-DMU-14 Model: To turn the vacuum cleaner on, push the On/Off
switch located at the rear of the unit to the ( I ) or ( II ) position (Fig. 6).
Use position ( I ), suction only, to clean hard floors and throw rugs. Use
position ( II ), suction and brush, to clean carpets.
To turn the vacuum cleaner off, raise the handle to the upright position,
push the On/Off switch to the ( O ) position then unplug power cord.
Always operate the vacuum cleaner with a vacuum bag installed.

How to Change the Vacuum Bag

1. Unplug the vacuum cleaner. Remove the bag compartment cover and
remove the used bag from the bag holder (Fig. 7).
2. Attach the new vacuum bag onto the bag holder (Fig. 8).
3. Pull the bottom corners of the new vacuum bag (Fig. 9).
4. Reinsert the tab on the end of the bag compartment cover into the grove
on the bag compartment housing. Press it into place and fasten the bag
compartment tightly (Fig. 10).
How to Change the Vacuum Bag
Fig. 7
Fig. 9
6
Fig. 4
Fig. 5
Fig. 6
Fig. 8
Fig. 10