Wheelchair Components; Handling; Folding Up And Unfolding; Optionstipping Tubes - Sunrise Medical Breezy 200 Notice D'utilisation

Before changing any of the adjustments of this wheelchair, it is important to read the corresponding section of
the user's manual.
It is possible that potholes or uneven ground could cause this wheelchair to tip over, especially when riding uphill
or downhill.
when riding over a step or up an incline frontally, the body should be leaning forward.

wHEELCHAIr COMPONENTS

we at SUNrISE MEDICAL have been awarded the ISO 9001 Certificate, which affirms the quality of our products
at every stage, from r & D to production.
This product complies with the standards set forth in EU directives.
Optional equipment and accessories are available at extra charge.
wheelchairs: (Fig. 1)
1. Push handles
2. Backrest sling
3. Armrest
4. Seat sling
5. Footrest

HANDLING

Folding up: First remove the seat cushion from the wheelchair and flip up the (platform) footplate or the individual
footplates. (Fig. 2)Take hold of the sling from underneath in the middle and pull upwards. The wheelchair will then
fold up. To fold your wheelchair until it is as small as possible, e.g., to put into a car, you can remove the footrests
(depending on the model). For this purpose, open the latch from the out-side and swing the footrest to the side.
Then the footrest only has to be drawn out of the frame tubing. (Fig.4)
Caution: Before folding the wheelchair, make sure that the stabilizer bar is removed.
Unfolding: Open the strap on folded frame prior to unfolding. (Fig.3)
Press down on the seat tubing (see picture). Your wheelchair is then unfolded. Now snap the seat tubing into position
in the seat saddle. This can be facilitated by slightly tipping your wheelchair. In this way, the weight can be taken
off of one rear wheel so that the wheelchair can be more easily unfolded.
Be careful not to get your fingers caught in the cross-tube assembly. rECLINING BACK (4º - 55º) (FIG. 5): By
pulling the 2 levers (1) at the same time the backrest is released and can be set to the required position.
releasing the 2 levers (1) will lock the backrest automatically in the new position. To bring the backrest back to the
upright position, just move it (no release necessary) to the required position.
Caution: The reclining back is only to be used in combination with the active anti-tips setting
Caution: The reclining back is only to be used in combination with a stabilizer bar. Please always make sure that
the stabilizer bar is locked in place on both sides.
Caution: In order to avoid any reduction in the cable function, you must make sure that the cables are not
completely taut.
Caution: when adjusting the back angle, be careful not to get your fingers caught.
Caution: Before adjusting the back angle, put the anti tip tubes in to the active position
Quick-release Axles for rear wheels The rear wheels are equipped with quick-release axles. The wheels can
thus be installed or removed without using tools. To remove a wheel, simply depress the quick-release button on
the axle (1) and pull it out. (Fig.6,7)
CAUTION: Hold the quick-release button on the axle depressed when inserting the axle into the frame to mount
the rear wheels. release the button to lock the wheel in place. The quick-release button should snap back to its
original position.
OPTIONS
Tipping Tubes
Tipping tubes are used by attendants to tip a wheelchair over an obstacle. Simply step on the tube to push a
wheelchair, for example, over a curb or step.
28
6. Casters
7. Quick-release axles
8. wheel locks
9. Handrim
10. rear wheel