Care And Maintenance; Accessories - Rothenberger ROMAX AC ECO Instructions D'utilisation

To turn the press jaw
The press jaw can be turned through 270°
depending on the application.
Operation
Use only system-compatible press fittings and press
jaws designed for them. The nominal size of the
press jaw must be identical with the nominal size
of the press fitting.
When inserting the pipe / press fitting
system, there is a risk of crush injuries for
the fingers or other body parts near the
press jaw!
1 Push the press fitting on to the pipe. Pull the
press jaw apart and insert the pipe with the
press fitting at rightangles.
There must be no foreign bodies between the
press contour and the fitting. If you fail to
ensure this, the pressing process will not
produce a perfect joint!
2 Press one of the two ON buttons until the
press cycle has finished, then release the ON
button.
3 Push the press jaw apart and take the machine
off the joint.
Do not start the machine while the piston retracts
or the emergency shutdown is pressed!

Care and maintenance

Disconnect the plug from the socket before
carrying out any work on the machine!
Check that the press jaws are fully functional.
Damaged press jaws must not be used and must
be sent to an authorised ROTHENBERGER repair
shop.
Check that the press jaw and drive rolls move
freely.
Check the bolt for signs of damage at regular
intervals. Have damaged bolts replaced by an
authorised ROTHENBERGER repair shop.
Clean and grease the drive rolls, the bolt and press
jaws when you have finished work.
Use only high quality pressing or ball bearing
grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work
must be carried out by an authorised
ROTHENBERGER repair shop.
D If the seal is damaged the warranty will be null and
void.
After 10.000 pressing cycles or 1 year have the
machine serviced by an authorised ROTHENBERGER
E
workshop.
Electro-hydraulic machine does not exceed 3 hours
in a -5° C storage.
Send the machine to the workshop in the carry
case only.

Accessories

The relevant accessories and an order form can be
found from page 78 onwards.
Disposal
Components of the unit are recyclable material and
should be put to recycling. For this purpose
registered and certified recycling companies are
available.
For an environmentalfriendly disposal of the non-
recyclable parts (e.g. electronic waste) please
contact your local waste disposal authority.
For EU countries only:
Do not dispose of electric tools with
domestic waste. In accordance with
European Directive 2002/96/EC on
waste electrical and electronic
equipment and its implementation as national law,
electric tools that are no longer serviceable must be
collected separately and utilised for
environmentally compatible recycling.
ENGLISH
9