Russell Hobbs 21500-56 Mode D'emploi page 66

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all
packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been supervised/instructed and
understand the hazards involved.
• Children must not use or play with the appliance.
• Keep the appliance and cable out of reach of children.
& To avoid injury, take care handling the blades, emptying the bowl,
and cleaning.
$ Don't add hot liquid (over 40°C), as it may be ejected due to
sudden steaming.
2 Misuse of the appliance may cause injury.
3 Unplug the appliance before assembly, disassembly, or cleaning.
4 Don't leave the appliance unattended while plugged in.
5 If the cable is damaged, it must be replaced by the manufacturer,
its service agent, or someone similarly qualified, to avoid hazard.
H Don't put the handle in liquid.
6 Don't use the wand in hot oil – even moderately hot oil can cause a nasty burn.
7 Don't try to chip ice, don't try to chop raw meat, and take great care with the blades.
8 Don't fit an attachment or accessory other than those we supply.
9 Don't use the appliance for any purpose other than those described in these instructions.
10 Don't operate the appliance if it's damaged or malfunctions.
5 FITTING/REMOVING ATTACHMENTS
1 Unplug the appliance before fitting or removing attachments.
2 Push the end of the handle into the attachment, and turn the handle to the right.
3 To remove the attachment, turn the handle to the left, and lift it off the attachment.
C SWITCH ON
4 Put the plug into the power socket.
5 Press the switch to start the motor, release it to switch off.
C SPEED CONTROL
6 Turn the speed control to the speed you want (min – max).
7 Use high speed with the wand.
8 With the whisk, use low speed to incorporate the mixture, then change to high speed for
mixing.
9 With the chopper, use low speed for a coarser chop, and high speed for a fine chop.
10 Use the chopper in bursts of a few seconds, otherwise you risk overdoing it.
11 Use low to medium speed with the creamer – take care not to over process.
12 Use low to medium speed with the disc.
household use only
66

Publicité

Table des Matières
loading

Table des Matières