Speck pumpen BADU EasyFit Eco VS Mode D'emploi page 29

POWER
Speed adjustable
1 2
INFO
POWER
Speed adjustable
1 2
INFO
POWER
Speed adjustable
1 2
INFO
After a voltage drop the pump automatically starts up again with the speed last set,
or remains stopped if it had been stopped beforehand.
The pump is not designed to be turned on and off at the mains power supply on a
daily basis. Use the control unit or the potential-free contacts to stop and start the
pump.
10/2014
3
S
0
3
S
0
3
S
0
VG 766.2130.052
Switching behaviour "0" (stop)
The switching behaviour of the digital input "0"
can be changed (inverted) by using the menu
item "0".
"cL" means that the motor is stopped at a
closed contact.
"oP" means that the motor is stopped at an
open contact.
Resetting
The motor is reset to the factory setting when
the "INFO" button is pressed for at least 10
seconds. The motor stops and "rESEt" is
displayed.
The pump's current power requirements are
shown in watt (P XXX) in the display when the
"INFO" button is pressed.
The control unit's display switches off after
three minutes without action.
EN 29