Speck pumpen BADU EasyFit Eco VS Mode D'emploi page 27

POWER
Speed adjustable
1 2
INFO
POWER
Speed adjustable
1 2
INFO
Note: The speed cannot be changed during the priming phase.
10/2014
3
S
0
3
S
0
VG 766.2130.052
Operation
Press the button "1", "2" or "3" to select the
preset fixed speed.
If the pump starts from a standstill, it starts up
in priming mode (in as far as it is activated)
and subsequently with the selected fixed
speed.
As long as the pump is in the priming phase a
bar moves in the first position on the display
from the lower, through the middle to the
upper position.
During operation the pump is started up to the
fixed speed directly, without priming time.
The motor is stopped by pressing the "0"
button. The "Power" LED flashes and the
display shows "oFF".
Setting the speeds
Press the button of the fixed speed that is to
be changed ("1", "2" or "3") and then change
the speed by using the "▲▼" buttons. The set
speed is stored directly and approached
immediately when the fixed speed is selected
again.
EN 27