Skil 2354 Consignes De Fonctionnement/Sécurité page 20

SM 1619X05087 05-12_SM 1619X05087 12-09 5/24/12
material is soft, drill only 2/3 the proper length.
If it is hard, drill the entire length.
Second, unclamp the pieces and drill the
second hole the same diameter as the screw
shank in the first or top piece of wood.
Third, if a flat head screw is used, countersink
the hole to make the screw flush with the
surface. Then, simply apply even pressure when
driving the screw. The screw shank clearance
hole in the first piece allows the screw head to
pull the pieces tightly together.
F STENING WITH
SCREWS
1. Drill 2/3 diameter and
2/3 of screw length for
soft materials, full
length for hard
materials.
Apply a slight
even pressure
when driving
screws.
FIG. 4
2. Drill same
3. Countersink
20
diameter as
screw shank.
same
diameter
as screw
head.
Screw