Operation Of The Camera Recorder - Panasonic AJ-RC10G Mode D'emploi

Basic operations

Operation of the camera recorder

1) Operation of the display interlocking
switch
Select the white balance settings by using the
PRE/A/B button and monitoring the PRE/A/B
display.
The state of the camera recorder filter is
displayed on the CC/ND display.
If two filters are installed on the camera
recorder, it is impossible to switch the filters
from the unit but it is possible to switch the
display by using the FILTER ND/CC button.
The ND filter is indicated with numerical
values while the CC filter is indicated with
letters of the alphabet.
The gain will change when using the two
buttons of the M.GAIN3 button and M.GAIN4
button and monitoring the GAIN display.
However, if super gain is set to ON in the
USER switch, operations of the MGAIN
button are disabled.
2) Operation of the USER switch
The USER MAIN/USER1/USER2 switch
functions the same as the USER switch on
the camera recorder. Functions of the USER
switch can be set and confirmed on the
camera menu or the USER-SW item on the
unit menu.
3) Operation of the ABB/AWB/BAR
switch
The ABB button and the AWB button function
the same as the switch for the white balance/
black balance of the camera recorder.
The lamp is on when the unit is operated.
If the button is pressed again during
operation, the lamp will flash for 5 seconds to
indicate an interruption of the operation.
If "PRE" is selected in the PRE/A/B selection
of the white balance, it is impossible to
change the setting, and the lamp will flash for
5 seconds.
The BAR button switches the camera output
to the color bar. The lamp is on when the
camera output outputs the color bar.
E-17
(Continued)
4) Operation of other switches
For the MATRIX ON button, the DTL OFF
button, A.KNEE ON button, HIGH COLOR
ON button, and the SHT ON button, the ON
and OFF states switch every time the button
is pressed. The lamp for the DTL OFF button
is on when the button is OFF. The lamps for
the other buttons are on when the button is
on.