Saving/Loading Of Scene Files Onto The Sd Memory Card; Handling Methods For The Sd Memory Card; To Load Data From The Card - Panasonic AJ-RC10G Mode D'emploi

Saving/Loading of scene files onto the SD memory card

It is possible to store up to 8 sets of settings for
the unit.
While data on the card are read or written, any
operation of the unit panel is inhibited. Insert the
SD memory card into the SD memory card slot
on the unit and operate the unit menu.
<Notes>
Use an SD memory card with a capacity of 8
MB or more. The maximum capacity of an SD
card that can be used on the unit is 2 GB.
The SD memory card must be formatted on
the unit.
Handling methods for the SD
memory card
Ensure that the SD memory card is inserted or
ejected in the proper direction.
SD memory card
slot
When the SD memory card is used for the first
time, execute CARD CONFIG in SYSTEM on the
unit menu.
<Note>
While data are being stored on the SD memory
card or data are being loaded from the SD
memory card, do not remove the SD memory
card. Otherwise, data on the SD memory card
may be damaged.
E-21

To load data from the card

1
When "SYSTEM" is selected using the
SHUTTER/SYSTEM button, the indication
"CARD-RD" is displayed on the LCD panel
together with the value displayed under the
indication and the title next to the indication.
2
Select the file to read out by changing the
numerical value in the Rotary Encoder 1.
If there is no applicable file, the indication
"NO FILE" is displayed on the LCD panel.
3
Press the Rotary Encoder 3.
When the indication "READ NO?" is
displayed on the LCD panel, turn the Rotary
Encoder 3 to select "YES?" and press the
Rotary Encoder 3 again to start reading out
the data.
4
The read operation starts and the indication
"ACTIVE" is displayed on the LCD panel.
While the data are loaded, the SD memory
card access lamp is on.
SD memory card
access lamp
5
When the reading the data is finished, the
SD memory card access lamp turns off and
the indication "OK" is displayed on the LCD
panel.
<Note>
If the data cannot be read properly, the
indication "READ NG" is displayed on the
LCD panel. Execute the load operation
again. If the load operation is not executed
properly, replace the SD memory card with a
new one.