Storage; Maintenance & Cleaning; Cleaning; Wear Of The Brushes - Gloria MULTIBRUSH speedcontrol PLUS Mode D'emploi

RZ_MULTIBRUSH_SC_DE_GB_FR_NL_979646-00_Text_GB 23.10.21 12:03 Seite 29
30
Do not put the device down on the
brush during work breaks or after use
as this will damage the bristles.
Always hang the device up or lie it
down as shown in the illustration.

7.2 Storage

CAUTION
You may be exposed to hazards that
could injure you when handling the
device.
You must therefore store the device
away from children.

Remove any dirt and debris.

Store the device hung up, dry and
protected from frost.
8 Maintenance & Cleaning
CAUTION
RISK OF BURNS CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or com-
ponents can still be very hot and may
cause burns.
important to observe the following
safety instruction:

Wear protective gloves during
maintenance and cleaning!

8.1 Cleaning

DANGER
RISK OF DEATH DUE TO ELECTRIC
SHOCK!
If the energised device comes into
contact with water, there is a risk of
seri ous injury or death! You should
therefore observe the following safety
instructions:
It is therefore
29

Switch off the device and disconnect
the power cord (D) from the power
supply.

Do not immerse the device in water
or spray or clean it with water.
The device must be protected
against moisture. However, if the
device does fall into water, immedi-
ately unplug the mains plug. Never
reach into the water if the device is
still connected!

Clean the outside of the device with a
damp cloth or soft brush. Do not use
abrasives or harsh cleaning agents.

Ensure that the ventilation slots are free
of dirt.

In cases of heavier soiling of the roller
brush and/or joint brush units,
dismantle for thorough cleaning (see
Assembly/Disassembly as described in
Chapter 6.1.2). Clean the brushes in
water or with a strong water jet and a
hard brush.

Only use original GLORIA spare parts
for repairs.

Repairs must be carried out by a
GLORIA service point.

8.2 Wear of the brushes

NOTE!

If the surface brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.

If the joint brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
9 Disposal & Legislation
9.1 Environmental protection &
disposal of the device

This symbol on the product, user man-
ual or packaging indicates that this