Safety Instructions For Connecting The Device; Safety Instructions For Operating The Device - Gloria MULTIBRUSH speedcontrol PLUS Mode D'emploi

RZ_MULTIBRUSH_SC_DE_GB_FR_NL_979646-00_Text_GB 23.10.21 12:03 Seite 22

Only use GLORIA original spares and
accessories
Never use worn, modified or defec-
tive replacement parts / accessories!
2.2 Safety instructions for
connecting the device
DANGER
DANGER OF ELECTRIC SHOCK!
Contact with energised cables/wires
or components may result in serious
injury or death! You should therefore
observe the following safety instructions:

If the power cable is damaged,
it must only be replaced by a repair
shop designated by the manufactur-
er in order to prevent a hazard !
Please contact the manufacturer or
the customer service department.

Ensure that the supply voltage
corresponds with the voltage (V)
of the device !

Only connect the device to an AC
grounded power outlet.

When using an extension lead, only
use a grounded cable for outdoor
use with a conductor cross-section of
at least 1.5 mm

The device should be operated using
a residual-current-operated protec-
tive device (RCD) with a release cur-
rent of no more than 30 mA. Ask your
elec trical installer!

The mains plug must be removed:
- In the event of faults during
operation
- Prior to any cleaning
- After use
2.3 Safety instructions for
operating the device
DANGER
DANGER OF ELECTRIC SHOCK!
If the energised device comes into
contact with water, there is a risk of
serious injury or death!
You should therefore observe the
following safety instructions:

Do not use the device with wet hands.
for the device.
2 !
22

Do not immerse the device in water
or spray or clean it with water. The
device must be protec ted against
moisture. However, if the device does
fall into water, immediately unplug
the mains plug. Never reach into the
water if the device is still connected!

NEVER drive over the extension
cable with the device!
CAUTION
RISK OF BURNS CAUSED BY HOT PARTS!
Parts of the device can become hot
during use and may cause burns.
It is therefore important to observe the
following safety instructions:

Wear protective gloves during
assembly and cleaning work!
Observe the following
precautions to prevent
and material damage due to misuse
and unsafe handling of the product.
Misuse can result in INJURIES.
WARNING
RISK OF INJURY DURING OPERATION!

Use the device
Work only within the specified
perform ance range.

Before each use, make sure that the
device is in perfect condition;
operation is prohibited if:
- the safety devices (start switch,
protective covers) and/or brushes
are damaged or worn.
- the device shows visible signs of
damage.
- the device may have been
dropped before.
- foreign objects have wrapped
around the drive shaft.
Never disable any safety devices.

Check area to be cleaned beforehand
to avoid damage to device / objects
or injuries to living beings. Stones,
pieces of wood, wires or the like, as
well as other foreign objects must be
removed. Objects that are caught by
the brushing equipment can be flung
out uncontrollably. Keep bystanders
away from the danger zone. In order
to prevent injuries, pay attention to
safety in the work area.
safety
injuries
as intended!