Using The Surface Brush On Rough Surface Structures; Using The Surface Brush On Wood Surfaces; Using And Replacing The Joint Brush - Gloria MULTIBRUSH speedcontrol PLUS Mode D'emploi

RZ_MULTIBRUSH_SC_DE_GB_FR_NL_979646-00_Text_GB 23.10.21 12:03 Seite 27
NOTE!
20
Whilst assembling the surface brush,
make sure that the side part of the
safety guard on guide arm (N) is firmly
connected to the safety guard and is
correctly sealed.
6.1.2 Using the surface brush on
rough surface structures e.g. tiles,
paving slabs, exposed aggregate
concrete, stoneware etc.
Figure 21
21
Place the switched-on device parallel on
the surface to be treated. Hold the
device at working angle and make sure
that the rubber lip on the safety guard is
just above the ground. Walk at an even
steady pace and push the device in
front of you. Depending on the degree
of soiling, apply light to medium pres-
sure on the surface brush, adapt your
pace of work to the degree of soiling.
NOTE!

Always work parallel and hold the
device away from your body.

When working close to edges, the
narrower side of the device should
point towards the wall.

In cases of stubborn dirt you can move
the device backwards and forwards on
the spot (like a scrubber), until the
required result is achieved.

Moist cleaning is also possible in cases
of heavy soiling. Use a sprayer to moist
the surface to be cleaned with water or
a cleaning agent, a GLORIA sprayer is
ideal for this purpose. After moit clean-
ing rinse the surface with water.
CAUTION
RISK OF INJURY FROM RUNNING
BRUSHING TOOL!

Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!
6.1.3 Using the surface brush
on wood surfaces (optionally
available as an accessory)
ATTENTION
Improper use of the device poses a risk
of damage to property! You should
therefore observe the following safety
instructions:

Never use the hard surface brush
with the black bristles for cleaning
wood surfaces, as the hard bristles
attack the surface of the wood,
thereby damaging it.
NOTE!

For cleaning wood surfaces use the
soft surface brush with the yellow /
black bristles. This is available as a
GLORIA accessory and is not in cluded
in the scope of delivery.

Assembly and operating instructions
can be found in the product informa-
tion "Surface
surfaces".
6.1.4 Using and replacing the
joint brush
Figures 22 - 24
22
Assemble the joint brush as described
in Chapter 6.1.2. Place the device
parallel with guiding wheel and joint
brush on the joint to be treated. Hold
the device at working angle and make
sure that the rubber lip on the safety
guard (H) is just above the ground.
NOTE!
23
To adjust the safety guard (I), turn the
7 click-stop safety guard to the posi-
tion described under point "22".
27
brush for wood