Gloria MULTIBRUSH speedcontrol PLUS Mode D'emploi page 26

RZ_MULTIBRUSH_SC_DE_GB_FR_NL_979646-00_Text_GB 23.10.21 12:03 Seite 26
ponents can still be very hot and
may cause burns.
It is therefore important to observe
the following safety instructions:

Wear protective gloves during
assembly!
Disassembly of surface brush followed by
assembly of the joint brush

Switch off the device and disconnect
the power cord (D) from the power
supply.
12
Open the locking device (L)
the guide arm (N), as shown in the
illustration.
13
With the lock applied (L) remove the
guide arm (N) and then the surface
brush (O).
14
Now open the locking device (L)
the drive arm (Q), as shown in the illus-
tration and remove, with the lock
applied, (L) the drive arm (Q) with safe-
ty guard (P).

The surface brush is now successfully
dismantled.
15
Put the guiding wheel (J), as shown in
the illustration, on the steering side of
the motor/gear unit (M). Now slide the
lock (L) into open position
and press the guiding wheel (J) further
onto the coupling shaft up to the stop.
Release the spring-loaded locking
device (L). The guiding wheel (J) is
locked when the locking device
independently returns to its original
position
16
Put the pre-assembled joint brush
unit, as illustrated, on the drive side of
the motor/gear unit (M). Slide the lock
(L) into open position
and press the joint brush unit further
, hold this
.
, hold this
into the drive shaft up to the stop.
Release the spring-loaded locking
device (L), the joint brush unit is locked
when the
independently returns to its original
posi tion .
Disassembly of joint brush followed
by assembly of the surface brush

Dismantle the joint brush according to
handling and function described above.
of
17
Open the locking device (L)
drive arm (Q) and, with the lock
applied, (L) put the drive arm (Q) with
safety guard (P), onto the drive side of
the motor/gear unit (M), as illustrated.
Release the spring-loaded lock (L),
the drive arm is locked when the
of
locking device independently returns
to its original position
NOTE!
17
If the drive unit (Q) cannot be pushed
onto the drive shaft, reach under the
safety guard (P) and turn the hexago-
nal drive until the drive unit (Q) slides
onto the drive shaft easily and without
force.
18
Put the surface brush (O) onto the
hexagonal drive and then the guide
arm (N), as illustrated, on the steering
side of the motor/gear unit (M).
19
Now slide the lock (L) into open posi-
tion , hold this and press the guide
arm (N) further onto the coupling shaft
up to the stop. Release the spring-load-
ed locking device (L). The guide arm
(N) is locked when the locking device
independently returns to its original
position .
26
locking device
of the
.