Through The Roof - Osburn 3000 Manuel D'installation

Through the Roof

Where vent pipes pass through an attic, a closet or any confined space, a floor or ceiling, only approved
venting components shall be used. To pass through a combustible wall or partition, the installation must meet
CSA-B365 standard for solid fuel-burning appliances and equipment.
1. Position appliance following appliance and venting system manufacturer's installation instructions.
2. Install a stove connector (1) or tee on the appliance flue collar. Seal with high temperature silicone.
If necessary, use an additional horizontal length between the flue collar and the tee.
3. Use a plumb bob to determine where the exhaust pipe will pass through the ceiling and roof.
4. Cut a hole in the ceiling and in the roof and frame the rough opening. Refer to the vent manufacturer's
instructions for dimensions and construction rules.
5. Install a ceiling support (2) in the rough opening and the first vent section following vent
manufacturer's instructions.
6. Install a firestop radiation shield (3) on any subsequent ceiling/floor, except for the attic where an
attic insulation shield is required (4).
7. Run the necessary section of vent vertically so the rain cap exceeds the highest point of the roof
at least 24" in United States and at least 36" in Canada.
8. Install roof support.
9. Install roof flashing (5), storm collar (6) and rain cap (7) as per manufacturer's instructions.
Installation Manual - 3000
7
6
5
4
3
2
1
Through the roof installation
Page 17