Electrical Connection - Osburn 3000 Manuel D'installation

Electrical Connection

Thermostat manufacturer's instructions always override the information published in the following section.
1. Unplug the power cord from the power outlet.
2. Connect the two thermostat wires to the terminal block located at the rear on the right hand side
of the stove when facing it. Loosen the two middle screws and insert the wires in the terminals.
Tighten the two screws.
3. Open the thermostat and connect the wires as per the manufacturer's instructions.
Thermostat connexion location
4. Connect one wire to "RH" and the other wire to "W". For further information refer to the
manufacturer's instructions.
Example of a connexion to a thermostat
Installation Manual - 3000 Page 23