Intended Use; Technical Data; Emission Levels; Parts Of The Device - Festool MFK 700 EQ Notice D'utilisation

English
Accessories that rotate faster than the per­
missible level can rupture.
– Do not work on the power tool if its elec­
tronics are defective as this may lead to ex­
cessive speeds. You can tell if the electron­
ics are defective if there is no smooth start-
up, if it is not possible to regulate the speed
and in the event of generation of smoke or
the smell of burning from the machine.
–
Wear suitable personal protective equip­
ment: Ear protection, protective goggles,
dust mask for work that generates dust,
protective gloves for working with rough
materials and for changing tools.
– Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
2.3

Emission levels

The levels determined in accordance
with EN 62841 are typically:
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
Vibration emission level a
three directions) and uncertainty K measured in
accordance with EN 62841:
The specified emission levels (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
load during operation.
– They represent the primary applications of
the power tool.
16
L = 81 dB(A)
PA
L = 92 dB(A)
WA
K = 1,5 dB
(vector sum for
h
a < 2.5 m/s
h
K = 1.5 m/s
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro­
tective measures must be defined in order
to protect the operator.
3

Intended use

The power tool is designed for routing wood,
plastic and similar materials.
The user is liable for improper or non-in­
tended use.
4

Technical data

Edge router
Power
Speed
Max. speed (no-load)
Tool holder
Max. routing diameter
Connection dia. d/e
Weight as per EPTA procedure
01:2014:
5

Parts of the device

[1-1] MFK 700 with large support router ta­
2
ble
2
[1-2] Side stop with guide bars and fine ad­
justment
[1-3] Extraction hood for large support rout­
er table with extractor connector
[1-4] Router table for edge veneer with fol­
lower roll and extraction hood (only in
SET items included)
[1-5] Gripping surface, locking for routing
depth
[1-6] Gripping surface
The specified illustrations appear at the begin­
ning of the Operating Instructions.
CAUTION
MFK 700 EQ
10,000–26,000 rpm
26,000 rpm
(optional: 6 mm, 1/4")
26 mm/1"
720 W
8 mm
27 mm
2.0 kg