Pulsar HELION 2 XP Mode D'emploi page 10

Restore default settings
Enter the Reset submenu with a short press of the
=
Reset
M (9) button.
With a short press of the UP/ DOWN buttons
=
select "Yes" to restore default settings or "No" to
abort.
Confirm selection with a short press of the M
=
button.
If "Yes" is selected, display will show "Return
=
default settings?" and "Yes" and "No" options.
Select "Yes" to restore default settings.
If "No" is selected, action is aborted and you
=
return to the submenu.
The following settings will be restored to their
original values before changes made by the user:
Operating mode of video recorder – video
=
Operating mode – Forest
=
Calibration mode – automatic
=
Language – English
=
Wi-Fi – off (default password)
=
Magnification – off (no digital zoom)
=
PiP – off
=
Colour palette – White Hot
=
Unit of measurement - metric
=
Warning: date and time settings, default pixel map
and remote control activation are saved.
Lens selection is used when replacing objective
lenses.
Lens
Selection of the lens type is important for the correct
selection
display of the optical magnification and adequate
operation of the Stadiametric rangefinder.
Replace the objective lens: to do this, move the
=
latch (13) backwards, turn the lens counter-
clockwise all the way and remove the lens.
Install a new lens, move the latch backwards and
=
move clockwise until the latch snaps.
Enter the submenu with a short press of the M
=
button.
With a short press of the UP/ DOWN buttons
=
select the desired lens: 28; 38 or 50.
Confirm selection with a long press of the M
=
button.
15
Remote control (bought separately)
Before operating the remote control (RC),
Remote
remember to activate it as follows:
Control
Press the M button, countdown starts (30 sec),
=
within which hold down for two seconds any RC
button.
If activation is successful, the message
=
«Connection complete» appears
If error occurs the message «Connection failed»
=
appears
The RC is activated and ready for use.
=
To unlink the RC, press the М button, wait for the
=
countdown to expire without pressing any RC
button for 30 sec.
All remote controls previously linked to your sight
=
are now unlinked.
Hold down the M (9) button to enter the main
=
Off
menu.
Select submenu with UP (10) and DOWN (8)
Microphone
=
buttons.
Press briefly the M button the enter the submenu.
=
Turn the microphone on/off with a short press of
=
the M button.
With the microphone on, you will have audio track
=
in your video. Microphone is off by default.
Defective pixel repair
When operating a thermal imager, defective (dead)
Defective
pixels (bright or dark dots with constant brightness)
pixel repair
may become visible on the sensor.
The defective pixels on the sensor may proportionally increase in size
when digital zoom is activated. Helion 2 thermal imagers allow the user
to repair defective pixels on the detector using a software-based method
or to abort deletion.
Enter the submenu with a short press of the M
=
button.
Select icon
=
A marker (H)
=
G
display.
On the right side of the display appears
=
H
"magnifying glass" (G) – a magnified image in a
frame with a fixed cross
x=95
I
y=99
detection of a defective pixel and to match the
pixel with the marker, horizontal and vertical
arrows for X and Y axes (I) showing marker's
movement.
.
. Repeat the procedure.
+
with a short press of the M button.
appears on the left side of the
, designed for easier
16