Specifcations - Toto EcoPower STD TELS10 Manuel D'installation Et D'utilisation

When the inlet screen is clogged, the flow rate will decrease. Decreased flow rate can
lead to insufficient power generation, which will deplete the backup battery prematurely.
Cleaning the screen (see ill. 1 & 2):
1. Turn the water off at the stop valves.
2. Remove controller cover and quick fastener.
3. Remove controller from hose adapter.
4. Remove screen and clean it with a brush.
IMPORTANT!
If flow regulator (or flow regulator assembly
for TELC103R-###E) falls out, reinstall it in the
correct orientation (O-ring side facing screen)
as shown. Otherwise, product will not
function properly.
5. Reinstall the cleaned screen.
6. Reinstall the controller into the hose adapter
until fully seated, and secure it with the
quick fastener.
7. Reinstall cover, securing it with the screws.
8. Open stop valves and check all connections.
Cleaning the nozzle (see ill. 3):
1. Remove the nozzle from the spout
with the supplied tool.
2. Clean the nozzle with a soft brush
to remove any dirt from the screen.
3. Re-install the nozzle in the spout.
Power supply
Sensor Detection Range
Water Supply Pressure
Water Supply Connection
Inlet Temperature range
Ambient Temperature
Humidity
Flow Rate
Duration
Volume per cycle
PERIODIC MAINTENANCE
Cleaning the Inlet Screen and Nozzle
SPECIFICATIONS
Hydropower Generation (self-powering power supply)
5-1/8"~ 7-7/8" (130 ~ 200mm)
Sensor is self-adjusting.
Minimum : 15 psi (100 kPa) (Flowing)
Maximum : 80 psi (551 kPa)
G1/2 compatible with ½ NPSM
1.0 gpm
10 seconds 10 seconds
0.18 gpc 0.09 gpc
(0.67 Lpc) (0.36 Lpc)
8
ill. 1
Remove Quick Fastener
ill. 2

Flow regulator for TELC103R-D##E
models is assembled inside an adapter.
Install assembly with correct orientation.

ill. 3
Open
Close
Key
39 ~ 110°F (4 ~ 43.3°C)
32 ~ 104°F (0 ~ 40°C)
Max. 90% RH
0.5 gpm
20 seconds
0.19 gpc
(0.72 Lpc)
U P
Flow Regulator

Screen
Hose Adapter

Brush
Spout
Nozzle
Spout
Nozzle
0.35 gpm
20 seconds
0.11 gpc
(0.44 Lpc)