Description Of The Controls; Prior To Use; Inserting/Removing Cylinder - SilverCrest SGR 150 C1 Mode D'emploi Et Consignes De Sécurité

6. Description of the controls

For safety reasons, the Start button (2) must be pressed and held to operate the electric food grater
(1). As soon as you release the Start button (2), the electric food grater (1) switches itself off.

7. Prior to use

Remove the electric food grater SGR 150 C1 and all accessories from the packaging and check
that all items have been included. Remove all protective foil. We recommend that you clean all
accessories again prior to their initial use.

7.1. Inserting/removing cylinder

Now, select one of the 5 enclosed cylinders (4, 5, 6, 7, 10) as required and push it as far as
possible into the feed chute (11). For the range of application of the individual cylinders (4, 5, 6, 7,
10), please refer to the diagram in the "Cylinders" section on page 75. Then attach the feed chute
(11) with the inserted cylinder (4, 5, 6, 7, 10) to the motor shaft (9). To facilitate this attachment,
an arrow () is indicated at the back of the feed chute (11). On the housing of the food grater (1),
an open lock is indicated on the right next to the motor shaft (9) and a closed lock
indicated above it. Proceed as follows:

Attach the feed chute (11) with the inserted cylinder (4, 5, 6, 7, 10) to the motor shaft (9) so
that the arrow () on the feed chute (11) points towards the open lock
the food grater (1).

Then rotate the feed chute (11) anticlockwise until the arrow () points to the closed lock
on the housing of the food grater (1).
If the feed chute cannot be used correctly, check whether the cylinder (4, 5, 6, 7, 10) was pushed
into it as far as possible.
Store the remaining cylinders (4, 5, 6, 7, 10) in the storage compartment (8) and close it with the
storage compartment cover (3). Then attach the storage compartment (8) to the electric food grater
(1).
To remove the cylinder, first remove the feed chute (11) from the food grater (1).

Then rotate the feed chute (11) clockwise until the arrow () points to the open lock
housing of the food grater (1).
You can then remove the cylinder (4, 5, 6, 7, 10) from the feed chute (11).
Electric food grater SGR 150 C1
on the housing of
English - 73
H
is
H
on the