Intended Use; Customer Service And Warrantly; Protection And Recycling; Electrical Wiring Diagramm - Trotec TTR 55 S Mode D'emploi

• H ave the exchanger surface of the absorption
rotor checked for fouling.
This work makes it necessary to open the
unit and must be carried out only by an
authorised specialist!
The unit is loud or condensate discharges:
• Check that the unit is standing on a level and
firm surface.
• Check that the unit is standing upright and sta-
ble.
• H ave the condensate trap or connection che-
cked for dirt deposits.
This work makes it necessary to open the
unit and must be carried out only by an
authorised specialist!

Intended use

The units are designed and equipped for drying
and dehumidification purposes. The units must
not be used for any other purposes.
The units must only be operated by suitably trai-
ned persons who are familiar with the operation
of the unit.
The manufacturer is not liable for any damage at-
tributed to failure to observe the manufacturer´s
instructions or applicable statutory requirements
or unauthorised changes to the unit.
NOTE
Any other operation other than that described
in these operating instructions is not permit-
ted. Non-observance will result in all liability
being disclaimed and any warranty clains will
expire.
Electrical wiring diagram
Thermostat
Heating element
Thermal fuse
Front
Heating element
Miniature fuse
Thermal fuse
Front
Heating element
ATTENTION
COPYRIGHT: An copying of this documents in
whole or part or use for purposes other than
the intended is strictly forbidden without the
prior written permission of TROTEC GmbH &
Co. KG.
Customer service and warranty
A precondition for any warranty claims is that
the dealer or his customer has completed and
returned the enclosed „Warranty document" to
TROTEC GmbH & Co. KG.
The units were repeatedly tested for perfect func-
tioning at the factory.
If malfunctions should occur that cannot be re-
medied by troubleshooting, your specialised dea-
ler or contract partner shoul be contacted.
NOTE
Only authorised specialists may carry out ad-
justments and maintenance.

Protection and recycling

Disposal of packaging
Think of the environment when
disposing of the packaging material.
Our units are carefully packed for transport and
delivered in sturdy cardboard packaging on a
wooden pallet if necessary.
The packaging materials are environmentally-fri-
endly and can be recycled. By reusing packaging
material, you make a valuable contribution to-
wards waste reduction and the conversation of
raw materials.
Heating element
Transformer
Transformer Input
Fan
Regeneration air
Operating manual – Dehumidifier TTR 55 S
Only dispose of packaging material at the fa-
cilities provided.
Disposal of old unit
This unit must not be disposed of together with
normal household waste but must be taken to
a special collection point for recycling electrical
and electronic equipment. The materials can be
reused according to their marking.
Reusing or recycling materials and old appliances
makes an important contribution towards protec-
ting the environment.
To find out about your nearest disposal facilities,
contact your local authorities.
Fin motor
Output
Fan
Regeneration
circuit
Adsorption
rotor
Control panel
Humidity sensor
Microswitch
Ioniser
B - 6
A - 2