Decommissioning; Unit Transport - Trotec TTR 55 S Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

shows that the unit has switched off.
1. Carefully pull out the full tank.
2. Open the slider in the corner of the container
and pour out the water into a drain.
NOTE
After each emptying, the condensate contai-
ner including float switch must be checked
for possible damage, fouling, etc.
3. C arefully place the emtied condensate contai-
ner with closed slider in the unit.
The „tank full" indicator light extinguishes and
the unit continues to operate fully automatically.
NOTE
The unit will only start with a correctly fitted
condensate container.
Continuous operation with external conden-
sate connection
The condensate containers are provided with a
special connection at the back.
After removing the sealing plug, a suitable drai-
nage hose can be connected.
Connection external
diameter = 11mm
NOTE
Also when using an external condensate hose,
the condensate container initially fills up to
the levels of the connection before condensa-
te discharges from the hose.
1. Remove the cover [F] from the rear wall of the
unit with a suitable tool.
F
2. A suitable drainage hose of sufficient length
can be rooted to the outside through the free
opening.
The condensate must preferably be discharged to
a lower located outlet in unsupervised continuous
duty.
When using an external container (tub, bucket,
etc.) the unit must be placed in a higher position.
ATTENTION
It must be ensured that the drainage hose is
routed to the drain with a gradient to ensure
that the condensate is able to flow out freely!
Operating manual – Dehumidifier TTR 55 S

Decommissioning

Switch off the unit with the ON/OFF
button on the control panel.
The mode LED extinguishes. The unit initially
switches off completely after lapse of a preset
overshoot time of 2 minutes.
ATTENTION
Never disconnect the unit from the power
supply during operation by pulling out the
mains plug. This can damage the control elec-
tronics. Damage of this kind is not covered by
the warranty.
If the units are not used for extended
periods of time, they must be
disconnected from the power supply.
The condensate container must be emtied
completely and dried with a clean cloth.
Pay attention to subsequently dripping con-
densate
Prior to possible storage, the units must be cle-
aned thoroughly and dried.
For storage purposes, the units should be cover-
ed with plastic sheeting and stored in an upright
position in a protected and dry location.
The units must only be stored in upright in a
suitable location protected from dust and direct
sunlight.

Unit transport

The units are provided with a handle for easy and
convenient transport.
F
• The unit must be switched off and the plug
removed from the power socket each time be-
fore the unit is moved to a different location.
• The condensate container must be emptied
completely.
B - 4
A - 2

Publicité

Table des Matières
loading

Table des Matières