Unit Description - Trotec TTR 55 S Mode D'emploi

Table of contens
Unit description ............................... B - 1
Installation ...................................... B - 1
Safety information ........................... B - 2
Commissioning ............................... B - 2
Decommissioning ........................... B - 4
Unit transport .................................. B - 4
Care and maintenance .................... B - 5
Troubleshooting .............................. B - 5
Intended use ................................... B - 6
Customer service and warrantly ...... B - 6
Protection and recycling .................. B - 6
Maintanance report ......................... B - 6
Electrical wiring diagramm.............. B - 7
Capacity graph ................................ B - 7
Technical data ................................. B - 8
These operating instructions must be read ca-
refully before commissioning/using the unit!
These instructions are part of the unit and
musst always be kept near to the site of in-
stallation or unit.

Unit description

The units are designed for universal and pro-
blem-free dehumidification.
Owing to their compact size, they are easy to
transport and install.
The units operate according to the adsorption
principle and are provided with ioniser, low noise
and maintenance recirculation fans as well as
power cord with plug.
The fully automatic control, the condensate con-
tainer with integrated overflow protection and the
drain connection for direct condensate discharge
ensure troublefree operation.
The units comply with the fundamental safety
and health requirements of the pertinent EU di-
rectives.
The units are reliable and easy to operate.
The units are used wherever dehumidification is
necessary and consequential damage (e.g. due
to mould formation) is to be avoided.
B - 1
B - 1
A - 1
The units are also suitable for drying and de-
humidification of:
• Living rooms, bedrooms, shower or cellar
rooms, lofts.
• U tility rooms, weekend homes, caravans.
• Museums, archives, laboratories.
• Wellness areas, washrooms and changing
rooms, etc..
• Garages, store rooms.
Operation
The units can be switched on and off with the ON/
OFF button. The LED of the last selected mode
lights up in the control panel. The recirculation
fan draws in the humid room air via the inlet gril-
le with filter, condenser and following adsorption
rotor.
In the internal regeneration circuit, the air flows
across a heating element, dries the adsorption-
rotor and passes the humid air through the con-
denser.
On the colder condenser, heat is removed from
the room air and cooled to below dew-point. The
water vapour contained in the room air deposits
as condensate.
Depending on the room air temperature and re-
lative humidity, the condensed water constantly
drips through the integrated drain connection into
the condensate container located below.
The conditioned drier air continuously mixes with
the room air. Due to the constant circulation of
the room air through the unit, the relative humidi-
ty in the room is gradually reduced to the requi-
red humidity (45% relative humidity).
A float switch in the condensate container inter-
rupts dehumidification via a microswitch when
the container is full. The units switch off with an
audible signal (5x) and the „FULL TANK" indicator
light illuminates on the control panel. This does
not extinguish until the emptied condensate is re-
fitted. The units return to the previously selected
mode.
The air flow is cooled on its way through or via the condenser to below the dew point. The water
vapour condenses and is collectes in a condensate trap and discharged.
saturated air
humid room
air
condenser
condensate container
Operating manual - Dehumidifier TTR 55 S
In an unsupervised continuous mode with exter-
nal conensate connection, the produced conden-
sate is continuously drained via a hose connec-
tion on the condensate container.
Installation
For optimal and reliable unit operation, the follo-
wing information must be observed in any event:
• The units must be installed stable and upright
to ensure unhindered condensate drainage.
• The units should be placed in the centre of the
room if possible to ensure optimal air circula-
tion.
• It must be ensured that the room air can be
sucked in and blown out freely.
• A minimum distance of 40 cm to walls and 60
cm free space above the unit must be maintai-
ned in any event.
• The units must not be installed in the immedi-
ate vicinity of radiators or other heat sources.
• Optimal room air circulation is achieved when
the units are installed about 1m above the
ground.
• The room to be dried or rather dehumidified
must always be closed from the ambient at-
mosphere.
• Open windows, doors, etc., as well as fre-
quently entering and leaving the room should
be avoided as far as possible.
• The units must not be used in dusty, chlorine
or ammoniacontaining atmospheres.
adsorption rotor
dehumidified
room air
regenerative
heatig element