Your Product; Introduction; Contents Of The Package; Getting Started - Marmitek IR Control 10 XTRA Guide De L'utilisateur

3 Your product

3.1

Introduction

Congratulations on your purchase of the IR Control 10 XTRA™. With it you can extend
the IR (infrared) signals of remote controls. The IR Control 10 XTRA™ makes it
possible to operate A/V devices while these are in a closed cupboard or when your A/V
equipment is out of sight.
3.2

Contents of the package

1 x IR Module
1 x IR Receiver
2 x IR Extension cable with one IR blaster LED
1 x IR Extension cable with two IR emitter LEDs
1 x AVR connection cable
1 x Power adaptor
1 x Manual

4 Getting started

4.1

How it works

Locate your A/V equipment in a closed cupboard, TV cabinet or even in another room.
The IR receiver must be installed in view of your own remote control. Stick the IR
blaster LED wherever you want in the cabinet and conceals the IR main module neatly.
Point the remote control at the IR receiver in order to send the appropriate command to
the IR LEDs (via the IR main module). These will then immediately pass this onto the
A/V equipment.
The IR Control 10 XTRA™ is made up of three main components;
1. IR Receiver
The IR Receiver receives infrared commands from your remote control and sends
these onto the IR Module.
2. IR Module
The IR Module receives infrared commands from the IR Receiver, processes
them and sends them onto all connected IR Extender Cables.
3. IR extension cable with two emitter LEDs or one blaster LED
The IR extension cable receives the infrared commands from the IR Module and
converts them via the IR LEDs or IR blasters into infrared signals. The IR emitter
LEDs have a limited range and therefore they have to be stuck accurately on the
IR receiver window of the A/V device you want to operate. An IR blaster LED
radiates much more infrared light (even up to 2 meters) so it easily can operate
multiple devices and therefore placing can be less accurate.
IR Control 10 XTRA™ 5