SI Analytics TitroLine 6000 Mode D'emploi page 163

Command Description
aaAA automatic allocation of device address
aaMC1...XX choosing a method
aaBF "filling burette". Aufsatz wird gefüllt.
aaBV output of dosed volume in ml
aaDA dose volume without filling, with adding the volume
aaDB dose volume without filling, reset of the volume
aaDO dose volume with filling, without adding the volume
aaGDM dosing speed in ml/min
aaGF filling time in seconds (min is 20, default 30)
aaES "ESC" function one step backwards
aaEX "exit" function.back to main menu
aafd µa "dead stop" measurement function
aafp pH measurement function
aaft temperature measurement function
aafv mV measurement function
aagdm dosing speed in ml/min (0.01 – 100 ml/min)
aaGF filling time in sec (adjustable 20 – 999 seconds)
aaGS output serial no. Of device
aaLC output of the CAL parameters
aaLD output of the measurement data
aaLR output report (short report)
aaM output of the preset measurement value (pH/mV/ug)
aaLI output method content
aaLO output documentation (as configured)
aaRH request of identification
aaRC send last command
aaRS report status
possible answers are:
"STATUS:READY" for ready
"STATUS:dosing" dosing
"STATUS:filling" filling
"ERROR:busy" if no interchangeable unit has been attached
aaSM start selected method
aaSEEPROM EEPROM reset to factory defaults
aaSR stop the actual function
aaSS titration start with the transfer of the pH end value
aaSYS5 adjust language to "German"
aaSYS1 adjust language to "English"
aaSYS2 adjust language to "French"
aaSYS3 adjust language to "Spanish"
aaVE Version number of the software
Chapter 6 Data Communication via RS-232 and USB-B interface
Reply
aaY
aaY
aaY
aa0.200
aaY
aaY
aaY
aaY
aaY
aaY
aay
aay
aay
aay
aay
aaY
aaY
aaGS08154711
aaY
aaY
aaM7.000
aaIdent:TL500
aa"last command"
aaStatus:"text
aaY
aaY
aaY
aaY
aaY
aaY
aaY
aaY
aaVersion
163