Removing An Interchangeable Unit; Programming The Titration Unit - SI Analytics TitroLine 6000 Mode D'emploi

Fig. 9.c
2.7.2

Removing an interchangeable unit

Removing the interchangeable unit is done in reverse order:
• Depress the black button on the left, and then pull the interchangeable unit forward as is shown in fig. 9.c
– 9.a.
! Please note: Removing the interchangeable unit is only possible as long as the piston is in the lower
position (zero position). Possibly, it may be necessary to press the <FILL> key first. !
2.7.3

Programming the titration unit

The data from the RFID transponder of the interchangeable unit will be read immediately (fig. 10).
Fig. 10
Following the reading operation, the input menu for the input of the reagents will be shown for approx. 10
seconds (fig. 11). The size of the interchangeable unit is displayed on the left side of the display (here 20 ml).
Fig. 11
Chapter 2 - Unpacking and first Operation
101