SI Analytics TitroLine 6000 Mode D'emploi page 104

104
Chapter 2 - Unpacking and first Operation
Pressing <↑> twice will take you to the <Rinsing> selection immediately (fig. 18).
Fig. 18
Confirm the selection by pressing <ENTER>:
Fig. 19
At this point you can select the number of rinsing cycles (Fig. 19). Initial filling requires a minimum of two rinsing
cycles. You can stop the rinsing operation (Fig. 20) at any time by pressing <STOP> and then resume rinsing
with <START>.
Fig. 20
While the initial filling or rinsing programme is being run, please place a sufficiently dimensioned waste vessel
under the titration tip.