146
The values can be set between 40 and 220 m. The pre-setting is 100 mV.
Low polarisation voltage:
High polarisation voltage:
4.6.6 Titration parameter pH Stat Titration (only TitroLine
Explanatory Notes for the pH Stat titration, see also section 4.6.2.4.
The titration parameters for the first Level (titration level) are already described in detail in the endpoint titration.
The other settings for the pH Stat titration are carried out in the sub-menu End of titration/Measuring settings:
Fig. 100 e
Fig. 100 f
Depending on the application and duration, the time unit is defined in second, minute or hour.
Fig. 100 g
For example, measurements can be entered in seconds up to 2 hours.
Chapter 4 Method Parameters
insensitive
sensitive
®
7000)