Information For The Owner; Information On Signs, Symbols And Markings - Hettich AvanFit 400 Instructions De Service Et De Montage

1. Introduction

1.2 Information for the owner

Please be careful to observe
• the contents of these operating instructions,
• the accident prevention regulations which are in effect in
the country of use or at the place of application,
• the acknowledged technical rules on working in compliance
with proper practices and safety standards.
Replacement parts used must meet the technical requirements
defined by Hettich Maschinentechnik GmbH & Co. KG. The tech-
nical requirements are always met when using genuine replace-
ment parts from the applicable replacement parts list.
Without the consent of Paul Hettich GmbH & Co. KG, the machi-
ne owner must not make any additions, alterations or modifica-
tions to the machine.
Only deploy trained or instructed personnel.
Define personnel responsibilities with regard to operating, servi-
cing and repair.
Please also note that under the code of practice in electrical
engineering only the following persons are allowed to work on
electrical components:
• qualified electricians
• persons instructed under the direction and supervision of a
qualified electrician

1.3 Information on signs, symbols and markings

The types of information, their signal words and symbols are
structured as follows in the operating instructions:
Danger
This danger note draws attention to an immedi-
ately dangerous situation that will lead to death
or serious injuries if the safety measures are not
followed.
Warning
This danger note draws attention to a potenti-
ally dangerous situation that may lead to death
or serious injuries if the safety measures are not
followed.
Caution
This danger note draws attention to a potenti-
ally dangerous situation that may lead
to minor or slight injuries if the safety measures
are not followed
Note
i
This advice draws attention to potential damage
to property or to a process of particular inte-
rest / importance that may occur if the safety
measures are not followed.
en
5