Checking For Proper Working Order With Material; Panels In Undefined Position - Hettich AvanFit 400 Instructions De Service Et De Montage

7. Starting up for the first time

7.1.2 Checking for proper working order with material

Once the machine has been checked without material and run
in, it is put into operation with components under operating
conditions.
Note
i
As you did on starting up without material, listen
for unusual noises and check to see if there is
any heat buildup.

7.1.3 Panels in undefined position

If compressed air is applied when the control voltage is switched
off (main switch OFF), the positioning cylinders first move to the
safe end position on account of the pressure difference in the
cylinders.
en
29