8. Operation
8.4 Sequence of movements
Setting drawer width (standard and custom widths)
•
Enter and confirm the width dimension (275 mm min. / 1200
mm max.) on the control panel
Setting drawer depth
•
Pull latch bolt, move to required dimension and let it snap
into place.
Repeat process on opposite side.
Note
i
Make sure that the same setting is selected on
both sides (left and right) for drawer depth.
Setting the drawer side profile receiver
Drawer side profile receiver closed - left-hand side
Receiver element in the BOTTOM position for standard drawer
side profile with 16 mm base thickness
Receiver element in the CENTRE position for low drawer side
profile with 8 mm base thickness
en
31