Switching Machine Off; Course Of Action In The Event Of An Emergency - Hettich AvanFit 400 Instructions De Service Et De Montage

8. Operation
• Place drawer rear panel and position it as far as the stop.
en
• Actuate the two hand switch system and the drawer compo-
nents will be joined together.
• The assembled drawer can be removed from the jig after
completing the assembly process.
34

8.5 Switching machine OFF

1. Turn OFF the main switch on the control cabinet ("0/OFF"
setting)
2. Prevent main switch from being switched back on again
without authorisation.
3. Switch off compressed air supply.
Fig. 20: Main switch – "0/OFF" setting

8.6 Course of action in the event of an emergency

An emergency action has the purpose of shutting off the supply
of electrical and pneumatic energy in hazardous situations.
In addition to the controlled procedure for shutting the machine
down, it can also be deactivated with immediate effect in an
emergency.
The machine has an emergency stop button (refer to Section
"Safety guards on the machine").
On activating the emergency stop, the hazardous energy (electri-
cal, pneumatic) is immediately shut off, taking the machine into
a safe state.
Unlock and acknowledge the pressed emergency stop button, only
then can you restart the machine!