Replace The Battery - Cochlear Baha 5 SuperPower Mode D'emploi

Masquer les pouces Voir aussi pour Baha 5 SuperPower:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Replace the battery

Remove the battery
Twist the battery module to remove it from the
processing unit.
Attach the battery
Align the battery module to the processor socket
to fit the parts together. Twist the battery module
as shown to attach the parts. The processor will
turn on automatically.
Lock/Unlock the battery
To increase tamper resistance, push the lock to
1
the far left with your battery cover locking tool
to lock the battery module.
2
Push the lock to the far right to unlock the
battery module.
Charge battery modules
Angle and fit the rechargeable battery module
1
into a socket on the Cochlear Nucleus
Charger.
Twist clockwise to connect.
2
3
Connect the battery charger to the power
adaptor and plug into mains power.
General processor care
Your Baha sound processor is a delicate electronic
device. Follow these guidelines to keep it in proper
working order:
• When not in use, turn off your sound processor
and store it free from dust and dirt.
• If you will not be using your sound processor
for a long period, remove the battery. Remove
your sound processor before applying hair
conditioners, mosquito repellent and or similar
products
8
See figure
2
See figure
2
See figure
9
See figure
10
Battery
®
Water, sand and dirt
Your sound processor is resistant to water, sand
and dust. However, it is still a precision electronic
device so the following precautions should be
taken.
1
If your processor ever gets wet, dry it with a
soft cloth, change the microphone protectors
and place it in the dry aid kit provided by
Cochlear for 8 hours.
If sand or dirt ever enter the processor, shake
2
the components carefully to remove it and
change the microphone protectors.
Using Share the Experience
See figure
12
Family members and friends can "share the
experience" of bone conduction hearing. The test
rod can be used by others to hear with the sound
processor.
To use the test rod:
1
Turn on your sound processor and snap the
Actuator unit onto the test rod using the tilt
technique.
Place the Sound Processing unit on the ear.
2
Hold the rod against the skull bone behind an
ear. Plug both ears and listen.
Note: Your hearing care professional may have
disabled some or all of the audible and/or visible
indicators.
See figure
11

Publicité

Table des Matières
loading

Table des Matières