Items Supplied - Vortice VORT HR 350 AVEL Livret D'instructions

ENGLISH
• If the power cable is damaged, have it replaced without delay by a Vortice Technical Support Centre.
• Should the appliance be dropped or suffer heavy impact, have it checked without delay by a Vortice Technical Support
Centre.
• The appliance must be installed in such a way as to ensure that under normal operating conditions, no one can come
into contact with any moving parts or live electrical components.
• In the event of: dismantling the appliance, with the appropriate tools; removing the heat exchanger; removing the motor
module; the appliance must first be switched off and then disconnected from the mains electricity supply.
• The electrical system to which the appliance is connected must comply with current regulations.
• Connect the appliance to the electrical power supply/socket only if the rated power of the supply is compatible with the
maximum rated power of the appliance. If not, contact a professional electrician without delay.
• Turn off the appliance at the main switch: if the appliance does not function correctly; before cleaning the outside of the
appliance, if the appliance is not going to be used for any length of time.
• The appliance cannot be used to pilot the operation of water heaters, stoves, etc.; neither must it drain into the
hot water ducts of such appliances.
• The appliance must expel air directly to the outside through a single dedicated duct.
• The flow of extracted air must be clean (i.e. free of grease, soot, chemical and corrosive agents and explosive or
flammable mixtures).
• Keep the air intake and outlet ports of the appliance free of obstructions, to ensure optimum air flow.
• Maximum operating temperature: 45°C.
• Specifications for the power supply must correspond to the electrical data on ID plate A (Fig. 1).
The appliance must be installed by a professionally
•
qualified technician.
The appliance must be wired to the power supply by way of
•
a multi-pole isolating switch with a gap of at least 3 mm
between contacts.

Items supplied

Fig. 2
Product components:
①
Insulated outer casing, made in plastic material;
②
Front panel, made in thermoplastic material;
③
Cross and counter flow heat exchanger, with ultra high efficiency in terms of heat exchange(>85%);
④
Motorfans, brushless type, low consuption and selectable speeds (+ presetted speeds);
⑤
Electronic manages:
- power input, monitoring and control of the appliance;
- bypass and no-frosting, thanks to temperature sensors;
⑥
Remote control (externally wired: wall mounted);
⑦
Filters for Fresh air (A) and Exhaust air (B):
- filtering class G3 (UK);
- filtering class M5 (NO UK);
- filtering class F5 (optional);
- filtering class F7 (optional);
⑧
Brackets Kit (No.3) for Wall mounting (supplied with product);
⑨
Brackets Kit (No.2) for Suspended Floor mounting (optional).
Fig. 3
Key to air connections:
(A) Fresh air intake from outside
(B) Stale air intake from room
(C) Clean air outlet inside the room
(D) Stale air outlet to outside
24