Waring Commercial WFP16SCD Mode D'emploi page 19

Masquer les pouces Voir aussi pour WFP16SCD:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

not expand beyond the MAX FILL LINE or it may leak through
the feed tube. If the mixture expands to the point where it leaks
out the feed tube, stop operation and reduce the contents of
the bowl to below the MAX LIQUID FILL LINE and continue
operation.
For whipped cream, simply add heavy cream and your choice
of flavoring into the batch bowl (do not use more than 6-cups
of heavy cream). Be sure the bowl is properly assembled with
the bowl cover. Press the ON button for continuous operation
and whip the cream until thick and fluffy.
To make butter, add heavy cream and your choice of
seasoning into the batch bowl. Be sure the bowl is properly
assembled with the bowl cover. Press the ON button for
continuous operation and whip the cream until the moisture
has mostly separated from the cream.
DICING OPERATION
• The dicing operation requires that product be sliced both
horizontally and vertically by the machine. The smaller the
dice required, the more difficult the cut is to achieve. Soft or
juicy product will tend to mush if the dice is too small or the
product is too soft. Cheese and meat are the opposite extreme.
Because of the consistency of cheese and meat, it is not
recommended that this kind of food be diced. Damage could
occur to the blades and/or motor and will not be covered
under warranty.
• During the dicing operation, attention should be given to the
finished product. Any food in front of the blade should be
removed before the feed chute is refilled. A visible change in
the product will occur when the dicing grid requires cleaning.
The best way to clean the grid is to remove the continuous-feed
lid and the slicing plate, and use the dicing grid punch
tool included to push through any product in between the
grid blades.
• When using dicing feature: Place dicing grid in chute on top of
indentations on the bowl. Pick up slicing blade and place on
drive shaft so that the blade is flush with the dicing grid. Pulsing
is the best method for this operation.
• When dicing, if the disc gets jammed, unplug the food
processor and remove the lid of the continuous-feed chute first.
19

Publicité

Table des Matières
loading

Table des Matières