Secondary Output Connections - ESAB Multimaster 300 Manuel D'instructions

sectIon 3
figure 4 - Voltage changeover terminal Board
208/230 Version shown Installed
figure 4a -
Input terminal Board
230/460/575 Vac Model
230 Vac Configuration
figure 4B -
Input terminal Board
230/460/575 Vac Model
460 Vac Configuration
figure 4c -
Input terminal Board
230/460/575 Vac Model
575 Vac Configuration
Clear Panel Hinges on
corner screw
Remove this screw only
This screw must remain
in place
Do not reMoVe
25
figure 4D -
Input terminal Board
208/230 Vac Model
208 Vac Configuration
figure 4e -
Input terminal Board
208/230 Vac Model
230 Vac Configuration
3.5 seconDarY output connec t Ions (figure 5)
The Multimaster 300/300X Welding System is completely self-
contained so that the front panel gun/torch connections are
internally connected to the welding polarity (DCEP or DCEN)
via the secondary output terminals depending on the welding
process being used.
figure 5 - polarity set-up
InstallatIon