Installing The Intenza+ Water Filter - Saeco XSMALL HD8645 Mode D'emploi

ENGLISH
14
9 Fill the water tank with fresh water up to the MAX indication.
The machine is ready for use.
,
Note: The first cups of coffee may be a bit watery, this is normal. The machine
needs to complete a few brewing cycles to optimize its settings.

Installing the Intenza+ water filter

We advise you to install the Intenza+ water filter as this prevents scale
build-up in your machine. You can buy the Intenza+ water filter separately.
For more details, see chapter 'Warranty and support', section 'Ordering
maintenance products'.
1 Remove the small white filter from the water tank and store it in a
dry place.
Note: Please keep the small white filter for future use. You will need it for the
descaling process.
2 Remove the filter from its packaging and immerse it in cold water
with the opening pointing upwards. Press the sides of the filter gently
to let out the air bubbles.
3 Turn the knob of the filter to the setting that corresponds to the
water hardness of the area you live in.
A Soft water
B Hard water (default)
C Very hard water
Note: You can test the water hardness with a water hardness test strip.
4 Place the filter in the empty water tank. Press it down until it cannot
move any further.
5 Fill the water tank with fresh water up to the MAX indication and
slide it into the machine.
6 Let the machine brew hot water until the water tank is empty
(see chapter 'Using the machine', section 'Hot water').
7 Refill the water tank with fresh water up to the MAX indication and
slide it back into the machine.
The on/off button illuminates continuously.
,
The machine is ready for use.