Measures For Troubleshooting; Shut-Down/Disposal Of The Installation; Shut-Down Of The Installation; Taking The Installation Back Into Operation - GILGEN KABA doorboy DBL-S Instructions De Montage Et D'exploitation

4.4.2

Measures for troubleshooting

Problem
Door does not move
Door opens but fails to close
Door or drive unit make
unusual noises
5 Shut-down / Disposal of the installation
5.1

Shut-down of the installation

If the drive unit is not going to be used for several months, it is recommended to pull out the power plug respectively
to switch off the main installation switch
5.2

Taking the installation back into operation

Before taking the installation back into operation, the door must be checked and the area of the door respectively
the track rail must be cleaned.
In order to check the smooth running movement of the door, uncouple it by means of the manual unlocking
mechanism. Manually move the door to and fro on the entire length of its travel distance. Then switch on the mains
supply and check if the drive unit and the safety elements function correctly.
5.3

Disposal

Disassemble the drive unit and the accessories into individual parts in order to be able to recycle the different
materials. No particular measures have to be taken with regard to environmental protection.
0552-999-04a_08.2001.p65
Cause
Mains supply interrupted/Main
installation switch switched
off/ Emergency cutout button
has been actuated
Radio transmitter /
push-button
Safety element STOP (EMS/ser-
vice door sw.) is triggered
Light barrier beam is
cut
Safety element REVERSE
has been triggered
Opening element
is continuously active
Dirty carrying or
guideway rails
Defective elements of
the drive unit
Modifications reserved
Measures in mm
0552-999/04a
DBL-S
19-19
Remedy
Switch on mains supply /
Check main fuse / Switch on
main installation switch / Re-
lease emergency cutout button
Replace the battery / Try to
actuate the door by means of
another control element
Check the safety element STOP
(EMS/service door switch)
Clean the opening of the light
barrier/Remove the obstacle
Check the reversing
safety element
Check the
opening elements
Clean and, if necessary,
grease
Install
spare parts
Tab. 6