Speed Dial And Memory Functions; Storing Numbers In Memory - Ameriphone CLS-45i Manuel D'utilisation

Speed Dial and Memory Functions

Storing Numbers in
Memory
The CLS45i stores 17 telephone numbers in
memory:
10 on the handset and
7 on the base.
Note: When storing numbers in either the
base or handset memory buttons, it's a good
idea to make a record of where you stored
them.There is no other means for checking to
see in which key you have stored a number.
Storing Numbers in the
Handset Memory Buttons
The unit must be in Standby mode.
The 0 through 9 number keys on your keypad
can be used to store a telephone number in
memory. Each stores one number.
Press MEM once and the display reads,
"ENTER MEMO NUMBER."
Press the DOWN (t) button until the display
reads "- -" in the top right corner and the
words "END OF RECORD" appear on the
second and third lines of the display.
Press MEM once to add a number. If no
buttons are pressed for 30 seconds, the
handset returns to Standby mode.
Enter the number to be stored (up to 16
digits).
Press INTERCOM and the display reads,
"ENTER NAME." Enter up to 12 characters,
using the numeric pad.You will note that in
addition to the numbers, there are also letters
on keys 2 through 9 (for example, the "2" has
"A," "B," and "C").
To create the name you would:.
• Press "2" once to select "A"
• Press "2" twice to select "B"
• Press "2" three times to select "C"
• Press "2" four times to select "2"; or
• Press DELETE to backspace and erase
the digit or character by the last cursor
position.
Press INTERCOM and the display reads
"ENTER MEMO LOCATION".
Enter the memory location (0 through 9) and
press INTERCOM to confirm.
If the location is empty (available), a long beep
indicates you have successfully stored that
entry and the display reads, "MEMO X" and
"STORED".
If the location is not empty, the display reads
"OVERWRITE" and "MEMO X? " This is ask-
ing you to decide whether or not you want
to leave the already-stored number in that
location or overwrite it with the new entry
you have just created.
If you do want to overwrite the location with
the new entry, press INTERCOM to confirm.
The display reads "MEMO X" and "STORED"
. Press ENTER to overwrite the location
with the new entry. Press EXIT to return to
Standby mode.
This memory storing sequence exits at any
wrong key sequence or if no key is pressed
after 30 seconds.
22