Programming The Memory Buttons - Ameriphone VCO Manuel D'utilisation

IMPORTANT INSTRUCTIONS
Special Features

Programming the Memory Buttons

You can automatically dial ten (10)
programmed telephone numbers
using the memory buttons shown in
Figure 24. Each button can be
programmed (or reprogrammed
using the same procedure) for a
phone number up to 15 digits
long.
RELAY REL MGS
POWER
M1 M2
a. a.
b. b.
Figure 24 - Memory Buttons
To Program the first 5 numbers into
a memory Button, Follow these
Steps:
1. Lift the handset and press PROG
as shown in Figure 25.
Figure 25 - PROG Button
16
AUTO ANS SPACE
X
SIGNAL
M3 M4 M5
a. a. a.
b. b. b.
SELECT MEMORY b
A
D
O
0
* #
P
E
HOLD PROG FLASH
AMPLIFY
TONE
LO HI
2. Enter the phone number on the
keypad (Figure 26) just as you
would dial it normally. If you
need to dial a "1" and/or the
area code, be sure to include it.
Figure 26 - Telephone Keypad
3. Select and press a memory
(M1-M5) button (Figure 24) to
store this number on that button.
4. Immediately hang up the
handset.
Note: Any number previously
stored at that button number will
be overwritten.
5. To change a stored number,
repeat the programming
process starting with step 1.
Note: Please do not program 911
into any memory button
REDIAL
VOL
J
4 G 6 M
5
K
H
N
L
I
O
7 P 8 9
T W
R
U X
S
V Y
*
O
0 #
P
E
HOLD PROG FLASH REDIAL