Ameriphone CLS-45i Manuel D'utilisation page 19

Installing and Using Your CLS45i
minute digits are set, AM/PM will flash.
11. Press UP (s) or DOWN (t) to for either
AM or PM.
12.Press INTERCOM once to select. After AM
or PM is selected, the time/date digits will
be blanked.
13.Press INTERCOM once to display the
time/date again. Or, press UP (s) or
DOWN (t) to go to the next menu.
Setting Caller ID On / Off
1. Press and hold CHANNEL for three (3)
seconds to enter the SETUP mode.
2. Press UP (s) or DOWN (t) until the
LCD display reads "CID MODE ON".
When it is off, the display reads "CID
MODE OFF".
3. Press UP (s) to set the CID ON/OFF
(default to ON).
4. Press INTERCOM once to enter the CID
selection mode.
5. Press the UP (s) or DOWN (t) button
to change the mode.
6. Press INTERCOM to confirm.
7. Press the UP (s) or DOWN (t) button
to go to the next menu.
Setting Auto-Talk On / Off
When this feature is activated, an incom-
ing call is automatically answered by picking
up the handset from the cradle while the
telephone is ringing.
NOTE: With Auto-Talk On, do not press
TALK to answer, as doing so will discon-
nect (hang up on) the caller; and the call is
automatically terminated when you place the
handset back into the cradle.You may also
disconnect by pressing TALK.
NOTE: With Auto-Talk Off, picking up the
handset from the cradle does not answer the
call.You will need to press TALK or SPEAKER
to answer the call.
1. Press and hold CHANNEL for three (3)
seconds to enter the SETUP mode.
2. Press UP (s) until the LCD display
reads "Auto-Talk ON/OFF" (default is
On). If Auto-Talk is Off, the display reads
"AUTOTALK OFF."
3. Press INTERCOM to enter the Auto-Talk
selection mode.The current mode charac-
ters will then flash (ON/OFF).
4. Press UP (s) or DOWN (t) to change
the mode.
5. Press INTERCOM to select.
6. Press UP (s) or DOWN (t) to go to the
next menu.
Setting the Area Code
1. Press and hold CHANNEL for three (3)
seconds to enter the SETUP mode.
2. While in SETUP press UP (s) button until
the LCD display reads "AREA CODE ?"
and "***" or last selected value "XYZ".
3. Press INTERCOM to enter the Area Code
selection mode.The digits change with the
first digit of the right set of digits ("XYZ ->
XYZ") flashing.
4. Enter your area code using the numeric
keys on the handset.
15