Memory Dialing - Base; Reviewing Memory Information On The Handset - Ameriphone CLS-45i Manuel D'utilisation

Speed Dial and Memory Functions
Storing Numbers in the
Base Memory Buttons
The memory buttons for the base are M1
through M4 and ER5 through ER7.
1. Press PROG.
2. Dial the number to be programmed (up to
16 digits).
3. Press PROG.
4. Press one of the memory buttons (M1
through M4, ER5 through ER7). A beep
follows.The number is stored.
Adding Memory Numbers fol-
lowed by an Extension or Menu
Choices.
NOTE: If you want to save a number that is
followed by an extension or menu choice,
program as you would a regular number,
with one exception: after you enter the main
number, press the REDIAL button. Example:
if you wanted to store the number 714 555
2232, but needed to reach extension 323, you
would press the following keys:
714 555 2232 REDIAL 323.
Changing Stored Numbers
on the Base
If you want to replace one of your stored
numbers with another, simply program the
new number on top of the old number.
For example, if the number you want to
replace is stored on M3 on the base, store the
new number on the M3 button.
Memory Dialing on the
Handset
There are two ways to do this.
Starting with the TALK or SPEAKER Button:
1. In standby mode, press TALK or SPEAKER
to open the line.
2. Press MEM and the desired memory key
location (0 through 9).The number is dialed
automatically.
Starting with MEM Button (the unit must be in
standby mode):
1. Press the MEM button once.
2. Press desired memory location key (0
through 9).
3. Press TALK or SPEAKER.The handset
opens the line and automatically dials the
number.
Memory Dialing on the
Base
1. Press the memory key where the number
is stored (M1, M2, M3, M4, ER5, ER6, ER7)
and the number is dialed automatically.
2. To dial hands-free using the speaker, first
press SPEAKER, listen for the dial tone, and
then press the memory key.
Reviewing Memory
Information on the
Handset
Unit must be in stand-by mode.
1. Press MEM once.The display reads,
"ENTER MEMO NUMBER".
2. Enter location number (0 - 9) or press
UP-(s) or DOWN (t) to review the last
to first location.
• If the location is not blank, the display
23