Setting Up Caller Id - Ameriphone CLS-45i Manuel D'utilisation

Installing and Using Your CLS45i

Setting Up Caller ID

The Caller ID SETUP procedure begins only
after the handset is fully charged.
Enter SETUP Mode
NOTE: In SETUP, if there is no input within
30 seconds, the program will default to the
last selection in that mode (e.g., Language) and
the CLS45i will return to Standby. If at any
time you want to exit SETUP and return to
Standby, press FLASH.
Press and hold CHANNEL for three seconds.
Setting Language on the Handset
1. Press and hold CHANNEL for three
(3) seconds to enter the SETUP mode.
The Caller ID display now reads, "SET
LANGUAGE."
2. Press INTERCOM once to enter the
Language selection mode.The current
selected language flashes.
3. Press UP (s) or DOWN (t) to scroll
through the language options.The displayed
language will change to "FRENCH" or
"SPANISH."
4. Press INTERCOM to select your
preference.
5. Press UP (s) or DOWN (t) to go to the
next menu.
Setting Contrast on the Handset
1. Press and hold CHANNEL for three (3)
seconds to enter the SETUP mode.
2. Press UP (s) or DOWN (t) to go to
the next menu.The display shows the last
selection.
3. Press INTERCOM once to enter the
Contrast Level selection mode.The current
selected level flashes.
4. Press UP (s) or DOWN (t) to change
the level.
5. Press INTERCOM to select your
preference.
6. Press UP (s) or DOWN (t) to go to the
next menu.
Setting Time and Date
The time-and-date stamp is automatically
updated when the first incoming Caller ID is
received.
The time will start from the default Time/Date
"12:00 AM 01/01".
If the time setting is lost during a power out-
age, the clock flashes when power is up again.
1. Press and hold CHANNEL for three (3)
seconds to enter the SETUP mode.
2. Press UP (s) until the display reads, "TIME/
DATE".
3. Press INTERCOM to start changing the
date.The display shows the current time
and date on the top line, e.g. "12:05AM
12/20" with the month digits flashing.
4. Press UP (s) or DOWN (t) to change
the month digits.
5. Press INTERCOM once to select. After the
month digits are set, the date digits flash.
6. Press UP (s) or DOWN (t) to change
the date digits.
8. Press INTERCOM once to select. After the
date digits are set, the hour digits flash.
9. Press UP (s) or DOWN (t) to change
the hour digits.
10.Press INTERCOM once to select. After the
hour digits are set, the minute digits flash.
11.Press UP (s) or DOWN (t) to change
the minute digits.
10.Press INTERCOM once to select. After the
14