Deleting A Stored Number; Transferring Calls From The Handset To The Base; Transferring Calls From The Base To The Handset; Three-Way Conference Calls - Ameriphone CLS-45i Manuel D'utilisation

Speed Dial and Memory Functions
shows location, name and telephone
number.
• If the memory location is blank, the
display shows location number in
the top right corner and the words,
"RECORD EMPTY."
3. Press UP (s) or DOWN (t) to review
the previous or next location.
4. Press "DOWN (t). At the end of the
memory the display shows "- -" in the
top right corner plus the words, "END OF
RECORD."
Press FLASH once to return the handset to
stand-by mode. Or, Press MEM again to add
a memory entry. If no key is pressed for 30
seconds, the handset will return to Standby
mode.

Deleting a Stored Number

The unit must be in standby mode.
1. Press MEM once.The display reads "ENTER
MEMO NUMBER."
2. Enter location number (0 through 9) or
press UP (s) or DOWN (t) to review
the last or first location.The display shows
location number in the top right corner
plus the name and telephone number.
3. Press DELETE to erase memory.The
display indicates this action.
4. Press INTERCOM to confirm.The display
reads "MEMO X" and "ERASED" together
with a success key tone. Use any other key
to return to memory review menu.
Transferring Calls from
the Handset to the Base
While talking on the handset with either the
TALK or the SPEAKER button engaged,
1. Press INTERCOM on the handset to place
the call on Hold and connect with the
intercom on the base.
2. Press SPEAKER on the base for the base to
pick up the call.
Note:You can retrieve the call again by
pressing TALK or SPEAKER.
Transferring Calls from
the Base to the Handset
The base must be in SPEAKERPHONE mode
(SPEAKER button must be On.).
1. Press INTERCOM on the base.This places
the call on Hold and the In-Use light chang-
es from steady On to flashing. A series of
rings occur on the handset and the display
reads, "PAGING" and "LINE ON HOLD."
2. Press INTERCOM on the handset
to talk to the base.The display reads,
"INTERCOM" and "LINE ON HOLD."
3. Press INTERCOM on the handset again to
bring the handset back into standard talk
mode
Three-Way Conference
Calls
JOINING A CALL IN PROGRESS ON
THE HANDSET:
1. Press SPEAKER on the base unit.The
handset display changes from "TALK" to
"CONF."
2. To disconnect the base from the confer-
ence call, press the SPEAKER button on the
base. Handset again reads "TALK."
24