Programming The Memory Buttons - Ameriphone XL-40 Manuel D'utilisation

Special Features
(continued)

Programming the Memory Buttons

You can automatically dial twelve
programmed telephone numbers
using the memory buttons shown
in Figure 19. Each button can be
programmed (or reprogrammed
using the same procedure) for a
phone number up to 15 digits
long.
Figure 19 - Memory Buttons
To program a button, follow these
steps:
1. Lift the handset and press
PROG as shown in Figure 20.
Figure 20 - PROG Button
11
M2 M8
M3
M9
M4 M10
M5 M11
M6
¤
1 2 A 3
B
0
* #
HOLD PROG FLASH
AMPLIFY
TONE
LO HI
2. Enter the phone number on the
keypad (Figure 21) just as you
would dial it normally.
Note: Press REDIAL if you want
to insert a brief pause between
two numbers.
Figure 21 - Telephone Keypad
3. Press a memory button (Figure
D
19) to store this number on that
E
button.
4. Immediately hang up the
handset.
Note: Any number previously
stored at that memory button
will be overwritten.
5. To change a stored number,
repeat the programming
REDIAL
process starting with step 1.
VOL
1 2 3
C F
J
6
4 G M
5
K
H N
L
I O
7 P 8 T 9 W
R U X
S V Y
*
O
0 #
P
E
HOLD PROG FLASH REDIAL