Thermal Protection - GYS GYSPOT EXPERT 200 Notice Originale

Translation of the original instructions
Automatic mode
1. Plug the power connector,
2. Press the ignition select button (13) until to turn the LED on (12 -
The machine is able to create the welding arc automatically.
The generator automatically detect the electrical contact and create the welding arc in less than 1 second. To create a
new arc, stop the contact with the gun tip for at least ½ second and establish contact again to form another arc.
For optimum operation, it is recommended to use the earth cable and guns originally supplied.

THERMAL PROTECTION

The machine is provided with an automatic thermal protection system. This system will stop the machine to prevent it
from overheating. The thermal fault indicator will light up if this is the case(fig.3 - 14).
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSPOT EXPERT 200 / 230 / 400
).
EN
15