Mettler Toledo LV12 Mode D'emploi page 18

4 Connect the AC/DC adapter to the connection socket at the rear of the device.
5 Connect the AC/DC adapter to a grounded electrical outlet.
ð When the LV12 is connected to the mains supply, an initialization (reset) runs for approx. 2
seconds. During this time, all LEDs light up. The instrument is then in the normal mode with pre-
selected intensity level 2.
Note
The basic setting of the vibration is selected so that most parts can be delivered without any
•
problems. For very small or large parts, this setting can be adjusted, see [Configure feeding rate
sets } Page 17].
14 Installation and Putting into Operation Automatic Feeder