Mettler Toledo LV12 Mode D'emploi page 17

NOTICE
Property damage due to short circuit!
Damage to the insulation on the AC/DC adapter or the cable can result in a short-circuit
and damage the device.
1
2
3
4
5
Note
When the device is connected to the mains, it starts automatically. To switch off the device and to
disconnect it from the power supply, the mains plug has to be plugged out.
The device is supplied with an AC/DC adapter and a country-specific power cable. The AC/DC adapter
is suitable for use with the following voltage range:
100 – 240 V AC, 50/60 Hz.
Proceed as follows to connect and set up the device:
1 Position the device on a firm surface. Pay attention to the required ambient conditions, see
[Selecting the location } Page 10].
2 Check the AC/DC adapter and the cable for damage.
3 Check whether your local power supply falls within the range of the delivered AC/DC adapter. If
this is not the case, under no circumstances connect the AC/DC adapter to the power supply, but
contact a METTLER TOLEDO representative.
Automatic Feeder
Only use the original AC/DC adapter which was supplied with your device.
Otherwise, the device may get damaged.
If the AC/DC adapter or the cable is damaged, pull out the power plug and have the
AC/DC adapter replaced.
Route the cable so that it cannot be damaged by external influences.
The power plug must always be accessible.
Keep moisture away from live parts. Moisture can result in short-circuit.
Installation and Putting into Operation 13