Connecting The Device - Mettler Toledo LV12 Mode D'emploi

3 Put the cover (3) on the device. Take the marks on the top
of cover as reference for the correct orientation (the marks
have to point to the front as indicated in the image). Push
the cover down until it snaps into place.
4 Fit the chute (4) to the two clamping blots at the lateral
opening and push it in as far as it will go.
5 Connect the device to the balance using the delivered
cables (either by USB or RS232 according to the used
balance).
6 Set up the device as described in [Connecting the
device } Page 12].

3.5 Connecting the device

12 Installation and Putting into Operation
WARNING
Risk of electric shock
1 To connect the device, only use the supplied three-core power cable with equipment
grounding conductor.
2 Only connect the device to a three-pin power socket with earthing contact.
3 Only standardized extension cable with equipment grounding conductor must be
used for operation of the device.
4 Intentional disconnection of the equipment grounding conductor is forbidden.
4
Automatic Feeder
3