Basic Setting And Advanced Mode; Standby; Cool Down Mode - Leister UNIROOF AT Mode D'emploi

9.2 Basic setting and Advanced Mode

9.3 Standby

9.4 Cool down mode

• The heating is switched o during the cooling-down process.
• If the air temperature is more than 100°C when the device is switched on, the device switches automatically to
Cool down mode.
• The cooling-down process is fi nished when the air temperature is less than 100°C for two minutes.
• If the heating is to be switched back on, you must confi rm this with the button (33).
62
In the Basic setting, move through the Setup menu to save the profi le, to Standby function,
Application Mode and Advanced Mode.
Additional information and setting options are available in Advanced Mode.
Standby mode is not set up when the devices are shipped!
The desired time interval can be defi ned individually by selecting the Standby menu with
the Up/Down arrow keys (30) and then setting the desired value with the Minus/Plus
arrow keys (32).
Once you have activated the Standby mode and the device remains active during the
defi ned time period, the device will switch over automatically into Standby mode, as
displayed in the Work display (41) with the corresponding symbol
(see illustration below).
The cooling down process will be initiated after an additional 180 seconds.
You can interrupt the process during these 180 seconds using the Confi rm button (33).