Accessories; Service And Repair - Leister TRIAC DRIVE Instructions D'utilisation

Accessories

On ne doit utiliser que des accessoires Leister.
• Overlap welding nozzle
• Pressure roller
• Single supporting carrier, double supporting carrier
• Guide handle
• Hot air blower TRIAC AT
• Hot air blower TRIAC ST
Training
Leister Technologies AG and its authorised Service Centres offer free welding
courses and training. Informationen below www.leister.com.
Maintenance
• Clean the overlap welding nozzle (16) with a wire brush.
• Check power supply cord (1), Power supply cord coupling (2) and connector
as well as extension cable for electrical and mechanical damage

Service and repair

• Have your Service Centre check the motor brushes after about 1,000 hours of
operation.
• Repairs should only be carried out by authorised Leister Service Centres. They
guarantee a correct and reliable repair service within 24 hours, using original
spare parts in accordance with the circuit diagrams and spare parts lists.
Warranty
• For this tool, we generally provide a warranty in accordance with the statutory /
country-specific regulations from the date of purchase (verified by invoice or
delivery document). Damage that has occurred will be corrected by replacement
or repair. Heating elements are excluded from this warranty.
• Additional claims shall be excluded, subject to statutory regulations.
• Damage caused by normal wear, overloading or improper handling is excluded
from the guarantee.
• Guarantee claims will be rejected for tools that have been altered or changed by
the purchaser
16